Asymtek TC V3 Spécifications télécharger pdf (Page 22)

3-8 Maintenance

5. If the input and output measurements are not equal, remove the access cover located under

the crank to access the transmission gear. Unscrew the two locking screws (Figure 3-7).

Insert one of the screws in the third hole to free the gear’s hub and tighten. Make necessary

adjustments and replace the locking screws.

6. Replace the access cover.

Figure 3-7 Conveyor Transmission Gear

7. Next, measure the width of the rail at the input (C) (Figure 3-8), at the middle section (D)

(Figure 3-9), and at the output (E) (Figure 3-10).

Figure 3-8 Input Rail

Figure 3-9 Mid-Section Rail

Locking

Screw

Hub

Gear

Insert screw here

to free hub

Locking

Screw

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Pas de commentaire

Asymtek TC V3 Spécifications Page 22